Golf GL L4-2.0L (AEG) (2001)
Constant Velocity Joint: Testing and Inspection
Inner Constant Velocity Joint, Checking
Disassemble joint to replace grease or check for wear and damage.
-
Swivel ball hub and ball cage.
-
Press out ball cage in direction of arrow.
-
Press balls out of cage.
NOTE: Ball hub and joint are paired and must not be interchanged.
-
Tilt ball hub out of cage over ball track (arrows).
-
Check joint housing, hub, cage and balls for pitting and signs of seizure.
NOTE: Excessive backlash in joint will be noticed as a knock during load changes. In such cases replace joint. Polished areas and ball track
marks are not reasons to change joint.
Installing:
-
Insert ball hub over both chamfers into ball cage. Hub can be installed in any position. Press balls into cage.
-
Insert hub with cage and balls at right angle to joint.