Golf GL L4-2.0L (AZG) (2001)
-
Disconnect 4-pin connector from Engine Coolant Temperature (ECT) sensor -G62- with Engine Coolant Temperature (ECT) sensor -G2- (arrow)
-
Bridge terminals 3 + 4 of connector using the respective adapter cables and observe the indication on display.
If indication jumps to approx. 140.0 degree C:
-
End diagnosis and switch ignition off.
-
Replace Engine Coolant Temperature (ECT) sensor (G62).
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If indication remains at approx. -40.0 degree C:
-
End diagnosis and switch ignition off.
-
Check wires according to wiring diagram.
Continuation of test if indication is approx. 140.0 degree C:
-
Disconnect 4-pin connector from Engine Coolant Temperature (ECT) sensor -G62- with Engine Coolant Temperature (ECT) sensor -G2- (arrow)
If indication jumps to approx. -40.0 degree C:
-
End diagnosis and switch ignition off.
-
Replace Engine Coolant Temperature (ECT) sensor (G62).
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes