Golf GL L4-2.0L (AZG) (2001)
-
Remove brake carrier with brake caliper. To do this remove brake caliper and hang up with wire or similar.
-
Mark installation position of bolts from ball joint to control arm.
-
Remove bolts - arrows - .
-
Press axle shaft out.
Note: When pressing axle shaft out ensure sufficient clearance is available.
-
Pull wheel bearing housing with ball joint out from control arm.
-
Remove axle shaft from wheel bearing housing and tie up.
-
The axle shaft must not hang down!
-
The inner CV joint will be damaged through overflexing.
-
Remove Phillips-head screw for brake disc and take out brake disc.
-
Remove cover plate.
-
Remove connecting link from control arm.
-
Release speed sensor wiring from suspension strut.
Caution: Place engine/transmission jack V.A.G. 1383/A underneath (danger of accident from falling parts when removing the wheel hub and the
wheel bearing).
Pulling out wheel hub
-
Insert thrust bolts -1 - in wheel bearing housing.
-
Install support - 2 - piston cylinder - 3 - with pull rod and special nut - 4 - .
-
Hold tool firmly pull out wheel hub.