Golf GLS L4-1.8L Turbo (AWW) (2001)
Remove small grommet -large arrow- for the ABS wheel speed sensor wire in the left front wheel housing
Note:
Tire and wheel removal is not necessary
Read supplier code -small arrow- (circled for illustration purposes only) of the ABS control module through the opening
Note:
The label showing supplier code is upside down in vehicle
^
If the ABS control module has part number 1C0 907 379 C and has supplier code 0321.3, the ABS control module must be replaced. Reinstall rubber
grommet and proceed to Section C
^
If the ABS control module has part number 1C0 907 379 C and does not have supplier code 0321.3, no further work is required. Reinstall rubber
grommet and lower vehicle on hoist
Section C
Section C - ABS Control Module Removal and Installation
^
Obtain radio code and record radio preset stations
^
Turn Ignition Switch to "OFF" position
^
Open hood and place fender cover in position
^
Disconnect the ground cable (GDN) from the negative (-) battery terminal
<-- Disconnect electrical connector -1- from mass air flow sensor -2-
<-- Remove vacuum line -7- attached to lower corner of air box (TDI vehicles only)