Golf GLS L4-1.8L Turbo (AWW) (2001)
-
Separate front exhaust pipe -A-.Refer to Exhaust Systems.
-
Remove cross support -B- below exhaust system.
-
Loosen heat shield -C- in forward area.
-
Remove heat shield -D-.
-
Unbolt selector housing from body.
-
Swing gear lever housing down and remove with selector cables.
Installing
Installation is carried out in the reverse sequence. Also, note the following:
-
Align gear lever housing parallel to body.
-
Distance to body must be same on both sides.
Adjusting selector mechanism.
Tightening torques
Selector housing to body 25 Nm
Cross support to body 25 Nm
Selector cable support bracket to transmission 25 Nm
Selector cable bolt to transmission selector lever 25 Nm
Balance weight to transmission selector lever 25 Nm
Disassembling and Assembling
5 Speed Manual 02J
Transmission selector mechanism, disassembling and assembling