volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Air Flow Sensor Plate|Page 4135 > < Air Flow Sensor Plate
Page 1
background image

Air Flow Meter/Sensor: Adjustments
Air Flow Sensor Plate Stop

Fig. 4 Air flow sensor adjustment clip

1.

Energize fuel pump for about 10 seconds to build proper fuel pressure.  The upper edge of the sensor plate nearest the fuel distributor should be
flush with the upper part of the cone Fig. 56.  The upper edge of the sensor plate may be as much as 0.5mm (0.020 in) below the beginning of the
upper part of the cone, but must not project up into the cone at all (this may cause poor cold starting).  Sensor plate must be installed with 'TOP' or
several punch marks facing up.

2.

Before adjusting the sensor plate position, remove fuel pump relay bypass, (to avoid excess fuel discharge while moving sensor plate).

3.

.Adjust the sensor plate position by bending the wire loop on the spring stop (arrow).

a. To raise the stop, lift the plate and pull the top part of the spring up with a hook tool.
b. To lower the stop, remove the sensor plate and use pliers to bend the spring.

Air Flow Sensor Plate|Page 4135 > < Air Flow Sensor Plate