Golf GTI L4-1781cc 1.8L SOHC (RD) (1987)
-
Installing tapered roller bearing outer race into clutch housing
5
Shim S2
-
Always 1 mm thick
6
Securing set
-
For attaching final drive gear to differential housing when servicing the final drive gear
-
Original production parts (rivets item 27) are not used
-
Torque 65 Nm (48 ft lb)
7
Clutch housing
8
Sleeve
-
Remove/Install - See: Clutch Housing
9
Oil seal
-
Remove/Install - See: Seals and Gaskets
10
Drive flange output shaft
-
Remove circlip (23) before removing
-
Turn lightly during removal
-
Press in carefully during installation
-
Threaded socket is opposite differential bearings
-
Do not damage thrust washer
11
Tapered roller bearing inner race, final drive gear side
-
First remove drive flange output shafts (10)
-
Adjust differential after replacement -