Golf GTI V6-2792cc 2.8L DOHC (AAA) SFI (1998)
_sfi/Page-895004.png)
-
Disconnect harness connector from Engine Coolant Temperature (ECT) sensor -G62-.
-
Disconnect 5-pin connector from ignition coil.
-
Set VAG 1630 digital potentiometer side A to 15 K Ohms and using test leads from VW 1594 connect to terminals 1 and 3 of disconnected
harness connector
-
Operate starter (second technician required).
-
The fuel injectors must pulsate and spray in accordance with firing order
-
Switch ignition off and check fuel injectors for leaks.
-
No more than 2 drops/minute may leak from each fuel injector.
NOTE:
When installing the fuel injectors make sure that the O-rings are not damaged.
