Golf III L4-1984cc 2.0L SOHC (1993)
NOTE: During removal and installation procedures, refer to the component location illustration and component notes.
REMOVAL
1. Remove ribbed drive belt.
2. Remove toothed timing belt.
3. Remove crankshaft sprocket by counter-holding the sprocket with tool No. 3099, or equivalent.
4. To guide the oil seal extractor, screw bolt from oil seal tool No. 3083, or equivalent, into crankshaft as far as it will go.
5. Unscrew inner part of the oil seal extractor tool No. 2085, or equivalent, two turns (approx. 3 mm) out of the outer part then lock using knurled
screw.
6. Lubricate threaded head of oil seal extractor, place it in position and while exerting firm pressure, screw into oil seal as far as possible.
7. Loosen knurled screw and rotate inner section against crankshaft until the oil seal is pulled out.
INSTALLATION
1. Lightly oil sealing lip of oil seal (do NOT use grease!)
2. Place guide sleeve from oil seal tool onto crankshaft journal.
3. Slide oil seal over guide sleeve.
