Golf III L4-2.0L (ABA) (1995)
Trunk/Liftgate Sensor/Switch (For Alarm): Service and Repair
Trunk lock alarm/central locking switch -F124-
NOTE: The following procedure describes removal and installation of the switch for the Golf. The procedure is similar for Jetta and Cabrio.
Removing:
-
Remove rear lid trim.
-
Disconnect 2-pin connector.
-
Remove rear lid lock.
-
Insert key into lock cylinder and turn lock cylinder clockwise to stop.
-
Carefully pry contact switch -1- from locating pins.
NOTE: Part numbers are for reference only. Always check with a Volkswagen Parts Department for the latest parts information.
Installing:
-
Press contact switch -2- onto locating pins.
-
Install retaining plate around contact switch.
NOTE:
-
Ensure contact switch wiring is correctly routed on rear lid lock.
-
Before installing rear lid lock, check contact switch installation position by operating lock cylinder.
-
Install rear lid lock.
-
Connect 2-pin connector.
-
Install rear lid trim.