Golf III L4-2.0L (ABA) (1995)
-
Remove cover from new motor in direction of arrow.
NOTE: Surfaces are coated with lubricant and must not come in contact with dirt, dust or other contaminants. If lubricant is required use high quality
lithium based grease.
-
Assemble regulator and motor together in direction of arrow and loosely install bolts (Torx T10 and T25).
-
Remove two (Torx T10) bolts previously installed on window regulator and motor then install loosely in remaining holes.
-
Tighten (Torx T25) bolts in order shown.
-
Tightening torque: 3.5 Nm (31 in. lb)
NOTE: Check the window regulator motor assembly for correct function before installing assembly.