Golf III L4-2.0L (ABA) (1995)
Tip mounting pin out of wire loop at front (arrow 1) and slide guide backward off tip of wire at rear.
-
To install, slide tip of wire into retaining pocket in back of guide (arrow 2) and tip mounting pin back into wire loop at front.
^
Rear guide part numbers: 1 HM 877 987/988
-
The completed assembly will look like this.
-
Hold completed cable assembly relatively straight and slide assembly back into frame. Ensure that each piece slides smoothly into its respective
channel.
-
Slide assembly forward until locking pawl reengages slot in frame.
-
Set cables for parallel running as described on pages 60-9 and 60-10 of the repair manual.
-
Reinstall drive motor.
Checking Cable Adjustment
CHECKING CABLE ADJUSTMENT:
-
Properly adjusted cables run parallel to each other assuring smooth operation of the sunroof.
-
Operate roof into tilt mode and then back to neutral position.
-
Inspect timing marks and ensure that marks for both cables line up and are equally spaced between left and right sides.