Golf III L4-2.0L (ABA) (1995)
Sensor Gear (6)
-
For engine speed sensor.
-
Always replace.
Sensor Gear Bolt (6)
-
Tighten in two steps as follows:
-
1st step, tighten to: 10 Nm (7 ft. lbs.).
-
2nd step: turn an additional 90° (1/4 turn).
Crankshaft (9)
-
Check Crankshaft Axial Clearance:
-
New: 0.07 to 0.17 mm (0.0028-0.0067 inch).
-
Wear limit: 0.25 mm (0.0098 inch).
-
Check Main Bearing Journal Radial (Oil) Clearance Using Plastigage:
-
New: 0.02 to 0.06 mm (0.0008-0.0024 inch).
-
Wear limit: 0.17 mm (0.0067 inch).
-
Do not allow the crankshaft to rotate while measuring radial clearance.
Lower Main Bearing Thrust Washers (10)
-
Install at block bearing No. 3.
-
Refer to illustration for installed position.