Golf III L4-2.0L (ABA) (1995)
Auxiliary Shaft Seal: Service and Repair
LEGEND
1
Auxiliary Shaft Oil Seal
-
To remove, remove sealing flange.
-
Install using installer tool No. 10-203, or equivalent.
-
Lightly oil sealing lip, do NOT use grease.
2
Woodruff Key
-
Ensure tight fit.
3
Bolt
-
Tighten to: 25 Nm (18 ft. lbs.).
4
Front Sealing Flange
5
Gasket
-
Always replace.
6
Cylinder Block
7
Bolt
-
Always replace.
-
Tighten in two stages:
-
First stage, tighten to: 60 Nm (44 ft. lbs.).
-
Second stage, turn an additional: 90° (1/4 turn).
8
Pressure Plate or Drive Plate
-
Note installed position of washer for mounting bolts.
-
Use counter holder tool No. 3067, or equivalent to remove and install.
-
Refer to Transmission and Drivetrain.
9
Bolt
-
Tighten to: 10 Nm (7 ft. lbs.).
10
Intermediate Plate
-
Must be located on dowels.
-
Do not damage/bend when assembling.
11
Rear Oil Seal Flange with Seal
-
Only replace complete.
-
Lightly oil sealing lip of oil seal, do NOT grease.
12
Front Crankshaft Oil Seal
13
Auxiliary Shaft
14
O-ring
-
Always replace
15
Sealing Flange For Auxiliary Shaft