Golf III L4-2.0L (ABA) (1995)
Exhaust Pipe: Service and Repair
Front Pipe
LEGEND
1
Bracket
2
Heat Shield Nut
3
Heat Deflector
4
Union
5
EGR Valve (If Equipped)
6
EGR Temperature Sensor (If Equipped)
7
Fitting
8
Gland Nut
9
Cap (If Equipped)
10
Bolt
11
CO Tap Tube (If Equipped)
12
Heated Oxygen Sensor (H02S)
13
Three Way Catalytic Converter (TWC)
14
Seal
15
Nut
16
Heat Shield
17
Front Exhaust Pipe
18
Gasket
19
Exhaust Manifold
20
Spacer Bushing
NOTE:
-
During removal and installation procedures, refer to the component location illustration above and component notes below.
-
After repairs be sure that the exhaust system is not under tension and that there is sufficient clearance between the exhaust system and the body.
-
If necessary, loosen all clamps and align muffler and exhaust pipes for sufficient clearance and even load distribution at all mounting rings.
-
Always replace self-locking nuts.
COMPONENT NOTES
Bracket (1)
-
For Heat Deflector.
Heat Shield Nut (2)
-
Tighten to: 25 Nm (18 ft. lbs.).