Golf III L4-2.0L (ABA) (1995)
Note
The .S at the end of the display means the system is in the setting/programming mode.
This table lists the programming displays and their function:
Service Reminder Indicator (SRI) Display Chart
- while the display shows OEL1.S, press the bottom digital clock reset button or the analog clock reset button
^ 7500(12,000 for Canada) now appears on display; miles/km can now be set for next oil change
Note
To illustrate the programming steps, an example will be used throughout the procedure. Although miles will be used as the unit of measure, the
procedure is the same for Canadian vehicles using kilometers.
Example:
An instrument cluster is replaced on a vehicle that has 5000 miles and is 4 months old. The 5000 accumulated miles must be subtracted from the
above displayed mileage setting of 7500 (7500-5000 = 2500). The new mileage seting should read 2500.
- press the bottom digital clock reset button or the analog clock reset button to decrease mileage setting in intervals of 500 until the correct setting is
displayed
Once OEL1.S distance counter is set correctly
- press odometer reset button
^ OEL2.S (time counter) will now appear in display
- press the bottom digital clock reset button or the analog clock reset button
^ 6 (meaning 6 months) now appears on display; time can now be set for next oil
change
Example:
In the previous example, the instrument cluster was replaced on a vehicle that was 4 months old. The accumulated time of 4 months must be
subtracted from the above displayed setting of 6 (6-4 = 2). The new time setting should read 2.
- press the bottom digital clock reset button or the analog clock reset button
to decrease time setting until the correct setting is displayed
Once OEL2.S time counter is set correctly,
- press odometer reset button
^ IN01.S (time counter) will now appear in display
-press the bottom digital clock reset button or the analog clock reset button