Golf III L4-2.0L (ABA) (1995)
Idle Speed/Throttle Actuator - Electronic: Testing and Inspection
Without VAG
Idle Stabilization Diagram
-
Remove the idle stabilizer valve harness connector.
-
Measure the resistance between the two terminals of the idle stabilizer valve.
-
The correct measurement should be 4 ohms - 12 ohms.
^
If NOT: Replace the idle stabilizer valve.
-
Reconnect the idle stabilizer valve harness connector.
-
The idle stabilizer valve should hum and vibrate slightly when the ignition is turned "ON".
^
If NOT: The Electronic Control Module (ECM) or harness may be defective.