Golf III L4-2.0L (ABA) (1995)
/Page-57004.png)
16-Pin Data Link Connector And Jumper Wire, Jetta Shown
9.
With engine STILL RUNNING, connect OBD1 adaptor to 16 Pin DLC connector. If using jumper wire join connectors J1 and J2 together.
10.
After approx. 4 seconds remove OBD1 adaptor from 16 Pin DLC or separate jumper wire connectors J1 and J2.
^
MIL will go OFF, come ON for 2.5 seconds, go OFF.
^
This confirms display signal has been received.
^
MIL will then display (flash) trouble code.
^
Should be code 0000.
11.
Turn ignition switch OFF, remove test equipment.
12.
Test drive vehicle for at least 10 minutes (minimum). During test drive these requirements must be performed.
^
Engine coolant temperature must be over 176°F (80°C) for at least 3 minutes.
^
At engine speed over 4600 RPM, press accelerator pedal briefly all the way down.
^
In 4th gear, starting from approx. 30 mph accelerate for about 4 seconds with accelerator pedal at half throttle.
^
ECM will not reset properly unless ALL REQUIRED SENSOR SIGNALS have been generated during road test.
