Golf III L4-2.0L (ABA) (1995)
Power Steering Pump: Service and Repair
NOTE:
-
Always replace seals.
-
Do not reuse hydraulic oil that has been drained.
-
Directly below the component legend are the Fig. numbers. Please refer to these for information regarding removal and installation instructions.
1- Sealing ring
2- Pressure line
3- Banjo bolt
-
Tighten to: 30 Nm (22 ft. lb.)
4- Suction hose
5- Hose clamp
6- Power steering pump
-
Manufacturer: ZF, Saginaw
-
Modification: pumps from Toyoda have also been installed and use the same removing and installing procedure
-
Only ZF pumps are supplied as replacement parts
-
Delivery pressure for all pumps is the same
-
Fill with oil before installing
-
Illustrations shows a Toyoda pump
7- Socket-head bolt
-
Tighten to: 25 Nm (18 ft. lb.)
-
Counter hold using water pump wrench VAG 1590 when loosening and tightening
8- V-belt
-
Checking condition
9- Hex bolts
-
M8 x 32: 25 Nm (18 ft. lb.)
-
M8 x 28 for Toyoda pump -6-: 20 Nm (15 ft. lb.)
10- Bolt
-
Tighten to: 45 Nm (33 ft. lb.)
-
M10x98