Golf III L4-2.0L (ABA) (1995)
Fig. 4 Turn signal switch -E2- and windshield wiper/washer switch -E22-, removing
-
Remove steering wheel. See: Steering Wheel/Service and Repair
-
Remove switch securing screws -arrows-.
-
Disconnect switch connector.
-
Remove turn signal switch -E2- andwindshield wiper/washer switch -E22- from steering column.
Fig. 5 Lock cylinder, removing and installing
Removing
-
Remove steering lock housing. See: Service and Repair/Steering Column Tube & Steering Wheel, Servicing
-
Mark steering lock housing for hole at intersection of points -a- and -b-.
Dimension -a- = 12 mm (15/32 in.)
Dimension -b- = 10 mm (25/64 in.)
-
Drill 3 mm (1/8 in.) diameter hole into steering lock housing at mark until lock cylinder stop spring is visible.
Hole depth: approx. 3 mm (1/8 in.)
-
Compress stop spring using opposite end of drill and pull out lock cylinder.
Installing
-
Insert lock cylinder into steering lock housing.
-
Insert key into lock cylinder.
-
Push lock cylinder fully into housing while gently turning key.
Steering column switches, connector wiring
Steering Column Switches, Connector Wiring
A. Ignition/starter switch -D-
1. Ignition/starter switch -D-, terminal 15 (B+ with key on)