Golf III L4-2.0L (ABA) (1995)
Fig. 3 - Axle Beam Bushing, Pressing In
-
Cylindrical part of bushing must protrude from axle by 8.0 mm ± 1.0 mm (0.32 ± 0.04 inch).
a
Bridge
b
Separator, Kukko tool No. 17-2, or equivalent
c
Puller, Kukko Tool No. 15-2, or equivalent
-
thrust piece, tool No. VAG 3111/3, or equivalent
-
Plate, tool No. VAG 3111/12, or equivalent
Fig. 4 - Mounting Bracket, Positioning On Axle Beam
-
Angle of inclination to axle beam = 12° ± 2°
Fig. 5 - Rear Axle Beam, Installing
CAUTION: The rear axle mountings must be under tension when installed.
-
Install all mounting bolts but do not tighten.
-
Align right hand mounting bracket so bolts are in center of elongated holes.
-
On left hand side press mounting bracket against axle beam bushing with a lever until gap on inside -arrow- is minimal.
-
Tighten all bolts to specified torque.