Golf III L4-2.0L (ABA) (1995)
7
Axle Shaft Self-locking Nut
-
Tighten to: 265 Nm (195 ft. lbs.)
-
Paint and/or corrosion on threads on outer constant velocity joint must be removed before nut is installed
-
Loosen/tighten only with vehicle on ground
8
Washer
9
Tie Rod End Nut
-
Tighten to: 35 Nm (26 ft. lbs.)
10
Tie Rod End
-
Removing/installing. See: Steering/Tie Rod/Service and Repair
11
Caliper Mounting Nut
-
Tighten to: 25 Nm (18 ft. lbs.)
12
Brake Caliper
-
Do not loosen hydraulic connection when working on suspension
-
Do not let caliper hang by brake hose; hang up with wire
13
Brake Pads
-
Removing/installing, refer to Brakes and Traction Control.
14
Nut
-
Tighten to: 50 Nm (37 ft. lbs.)
15
Brake Disc
16
Screw
17
Wheel Hub
-
For vehicles without ABS
-
Pressing out, refer to Fig. 3 below
-
Pressing in, refer to Fig. 8 below
-
Removing bearing inner race, refer to Fig. 4 below
18
Wheel Hub
-
For vehicles with ABS
-
Pressing out, refer to Fig. 3 below
-
Pressing in, refer to Fig. 8 below
19
Rotor For ABS Wheel Speed Sensor
-
Only for vehicles with ABS
20
Brake Splash Shield Bolt
-
Tighten to: 10 Nm (82 inch lbs.)
21
Splash Shield
22
Circlip
-
Make sure clip is correctly seated
23
Wheel Bearing
-
Pressing out, refer to Fig. 5 below
-
Always replace (destroyed when pressed out)
-
Pressing in, refer to Fig. 7 below
24
Wheel Bearing Housing