Golf III L4-2.0L (ABA) (1995)
-
Quantity used. See: Application and ID
5
Corrugated washer
6
Circlip
-
Removing and installing, refer to: Fig. 1, below.
-
Installation position, refer to Fig. 2, below.
7
Spring supporting plate
-
With springs
-
Installation position, refer to: Fig. 2, below.
8
Spring supporting ring
9
Piston
-
Sealing lips are vulcanized to piston
-
Moisten sealing lips with ATF before installing
-
Turn piston slightly when installing
10
Clutch housing
PROCEDURES
Fig. 1 Circlip {arrow), removing and installing
-
Press spring supporting plate down with 3267 enough so that Circlip can be removed and installed.
NOTE: Do not damage clutch housing ball valve.
Fig. 2 Spring supporting plate/circlip, installation position
-
Circlip (arrow) must be seated in the groove of clutch housing.
-
Spring supporting plate must be centered relative to hub.
096 Transmission
REVERSE CLUTCH - K2- 096 TRANSMISSION
Disassembling and Assembling