Golf III L4-2.0L (ABA) (1995)
Valve Body: Service and Repair
01M Transmission
COMPONENT NOTES AND INFORMATION
CAUTION: Do not run the engine or tow the vehicle with the oil pan removed or when there is no ATF in the transmission.
NOTE:
^
The valve body or the conductor strip can also be removed when the gearbox is installed.
^
The conductor strip can be removed individually.
Remove the starter motor on vehicles with V6 engine to remove the conductor strip.
^
After re-installing the oil pan, fill with ATF, refer to Topping Up Transmission oil.
^
Always replace a valve body which is fouled or faulty.
1
Plug
-
Always replace seal, refer to Fig. 2, below.
-
Checking ATF level and topping-up, refer to Topping Up Transmission oil.
2
Overflow tube
-
Remove to drain ATF, refer to Fig. 1, below.
-
Thread in to stop Checking ATF level and topping-up, refer to Topping Up Transmission oil.
3
Oil pan
4
Bolt
-
Tighten to: 12 Nm (9 ft lb)
5
Magnet
-
Install in recess in oil pan
6
Spacer bushing
-
Press into gasket
7
Gasket
-
Always replace
-
Press spacer bushings into gasket
8
ATF screen
-
Installing, refer to Fig. 10
9
Bolt
-
Tighten to: 5 Nm 144 inch lb)
10
Gasket
-
Always replace
-
Install in valve body