Golf III L4-2.0L (ABA) (1995)
17
Over-center spring
18
Over-center spring support
-
Insert in bracket
19
Rubber guide
20
Rubber stop
21
Clutch cable attachment components
22
Balance weight
-
With integral clutch cable attachment components
-
For vehicles with Diesel engine, up to August 1993 production only
-
Adding weight to reduce clutch pedal vibration in vehicles, refer to Fig. 2 below.
CAUTION: Part numbers are listed for reference only. Always check with the parts supplier.
23
Release shaft
24
Lever stop
25
Transmission
26
Bracket
27
Attachment bolt
-
Bracket to body
Fig. 1 Installation Position For Brake Pedal And Clutch Pedal Pivot Pin
-
Recess -arrow- is on clutch-pedal side
Fig. 2 Balance Weight On Clutch Release Lever
-
Beginning August, 1993, a balance weight will be attached to the clutch release lever in cases where excessive noise and vibration are
transferred to the clutch pedal.
-
The 200 gram balance weight installed on vehicles with 1.9 liter Diesel engine (up to August 1993) is discontinued.
-
Tighten to: 25 Nm (18 ft lb)
NOTE: The new balance weight can be installed on current vehicles where necessary to address complaints about clutch pedal noise and
vibration.
REMOVAL
-
Disconnect clutch cable from transmission, refer to Cable Replacement. See:
-
Remove interior trim panel at lower left driver's side, refer to Body and Frame.