Golf III L4-2.0L (ABA) (1995)
-
Checking ring for wear
^
Friction surface is coated with molybdenum
^
Press synchronizer ring onto gear cone and measure gap -a- with feeler gauge
^
a = New: 1.15-1.75 mm (0.045-0.069 in)
^
a = Wear limit: 0.5 mm (0.020 in)
27
Transmission housing
28
Input shaft shim
-
Input shaft adjustment not required
-
Original adjustment shim should be reinstalled after repairs
-
If no shim was installed, re-assemble without shim
-
When bearing or clutch housing/transmission housing is replaced, shim installation is not required
29
Thrust washer
-
Installation position