GTI L4-2.0L (AEG) (2000)
VAG 1383A Engine/transmission jack
^
VAG 1383A Engine/transmission jack
Removing
WARNING: Vehicle must be standing on its wheels when loosening or tightening 12 point axle nut.
-
Loosen 12-point axle nut.
-
Lift vehicle to relieve load on front axle and remove noise insulation.
-
Remove bolts (arrows).
-
Press axle shaft out. Position tool as shown.
NOTE:
^
When pressing the drive axle out make sure that sufficient clearance is available.
^
Do not allow drive axle to hang by inner CV or triple-rotor joint to avoid damaging bearing surfaces. Tie drive axle to stabilizer bar or other
suspension component if it is to remain attached to drive flange.
^
Do not flex inner CV or triple-rotorjoint more than 25 degrees from its original angle.
-
Pull wheel bearing housing with ball joint out from control arm.