GTI L4-2.0L Turbo (BPY) (2007)
Body Control Module: Service and Repair
Relay Carrier, Removing and Installing
Comfort System Central Control Module J393
General Information:
Comfort System Central Control Module J393 performs the following functions:
-
Sunroof control (issues enabling)
-
Window regulator control (issues enabling)
-
Central locking system control
-
Anti-theft warning system control
-
Radio receiver
-
Rear lid closing
-
Comfort operation
Some of the functions listed above can be adapted.
NOTE:
-
Additional information:
Owners Manual
Wiring Diagrams and Component Locations
On Board Diagnostic (OBD), functions:
Comfort System Central Control Module J393 is controlled by an internal microprocessor with On Board Diagnostic (OBD) capability. If malfunctions
occur in monitored components, Diagnostic Trouble Codes (DTC) will be stored in memory.
Troubleshoot Comfort System Central Control Module J393 malfunctions by performing OBD program using Vehicle Diagnosis, Testing and
Information System VAS 5051/5052 in operating mode "Guided Fault Finding".
Comfort System Central Control Module J393, removing and installing
Removing:
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Remove glove compartment.
-
Pull retaining tab -1- of bracket of Comfort System Central Control Module J393 in direction of -arrow- and slide Comfort System Central Control
Module J393 until recesses -2- stand over recesses -3-.