GTI L4-2.0L Turbo (BPY) (2007)
/Page-2230003.png)
-
Remove any adhesive residue that is still present using the erasure disc for stripe remover erase disc Z 432 290 TE.
-
Always clean adhesion surface immediately prior to adhering outer door seal with adhesive removal solution D 002 000 10.
-
Adhesion surfaces must be free of dust and grease and there must be no residual adhesive present.
-
Vulcanized point - arrow b - of outer door seal - 1 - is located in center area of door entry sill.
-
Pull off foil cover and apply seal onto door in upper radius - arrow a -. Do not stretch outer door seal excessively so that the seal is not too long at
the end.
-
Press entire adhesive area of seal onto door all around using application roller 3356.
-
After 10 minutes, perform test for proper seal seating.
NOTE: Part numbers are for reference only. Always check with your Parts Department for the latest part number information
Checking seal for secure seating
Check seal for firm setting 10 minutes after adhering the seal.
