GTI L4-2.0L Turbo (BPY) (2007)
Removing
Component location:
The control module is bolted to the hydraulic unit and is located at right in engine compartment.
CAUTION: Do not bend brake lines near the hydraulic unit!
-
Read out and note present control module coding.
-
Note or request radio code on vehicles with coded radio if necessary.
-
Disconnect battery.
-
Remove engine cover.
-
Release control module connector in direction of arrow - 1 - and pull off - 2 -.
-
Install Brake Pedal Actuator V.A.G 1869/2.
-
Attach bleeder hose of bleeder bottles to left-front and left-rear brake caliper bleeder valves and open bleeder valves.
-
Operate brake pedal using Brake Pedal Actuator V.A.G 1869/2 at least 60 mm.
-
Close left front and left rear bleeder valves.
-
Do not remove Brake Pedal Actuator V.A.G 1869/2.
-
Place sufficient lint-free cloths under control module and hydraulic unit.
Make sure that brake fluid does not come in contact with the terminals.
-
First, mark both brake lines from master cylinder - A and B - and remove from hydraulic unit.
-
Plug brake lines and threaded holes immediately with sealing plugs from repair kit Part No. 1H0 698 311 A.
-
Mark brake lines (brake caliper) - 1 to 4 -, remove and seal.
-
Pull hydraulic unit with control module upward out of shock absorbers.
Control module, removing from hydraulic unit
Note:
^
Separation from control module and hydraulic unit is not possible on vehicles with hydraulic brake booster or hill assist.
-
Set hydraulic unit with control module downward on to a clean, level surface.