GTI L4-2.0L Turbo (BPY) (2007)
-
Disconnect connector for Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) G130 -arrow- and free up cable.
NOTE: Flex joints in front exhaust pipe must not be bent more than 10 degrees, otherwise they may be damaged.
-
Disconnect exhaust system at clamping sleeve -arrows-
-
Remove front cross member for underbody -arrows-
-
Remove bracket for exhaust system -arrows-.
-
Remove catalytic converter with front exhaust pipe.
Installing:
Installation is in reverse order of removal, note the following:
-
Coat turbocharger stud bolts with hot bolt paste.
-
Replace gaskets and self-locking nuts.
-
Install exhaust system free of stress.
Torque specifications
Component
Nm
Front exhaust pipe to turbocharger
40
Tunnel bridge to body
25
Mount to subframe
25
Clamping sleeve
25