GTI L4-2.0L Turbo (BPY) (2007)
Air Door Actuator / Motor: Service and Repair
Automatic A/C System - Climatronic
Recirculation Flap Motor V113, Removing and Installing
Recirculation Flap Motor V113, Removing And Installing
Removing
-
Remove glove compartment.
-
Mark connector -A- if necessary (to rule out an interchange in the event several connectors are disconnected at the same time).
-
Disconnect connector -A-.
-
Disengage catches -C- and -D- for bracket -B- on intake housing and remove bracket -B- (toward rear).
-
Remove positioning motor -A- from air intake shroud.
Installing
Install in reverse order of removal.
NOTE:
-
After installing, function of recirculation flap must be checked.
-
Initiate "Basic Setting" function with Vehicle Diagnostic, Testing and Information System VAS 5051/5052.
Fresh/Recirculating Air Door Motor V154, Removing and Installing
Fresh/Recirculating Air Door Motor V154, Removing And Installing
Removing:
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Remove glove compartment.
-
Remove motor cover.
-
Disconnect electrical connection from motor -1-.
-
Remove motor -1-.
Installing: