GTI L4-2.0L Turbo (BPY) (2007)
-
Mark connector -C- to control motor (danger of interchange with other connectors of same construction).
-
Remove heater core cover.
-
Disconnect electrical connection -C- from Left Temperature Flap Motor V158.
-
Remove cover -A-.
-
Remove bolts -D- and remove Left Temperature Flap Motor V158 -B-.
-
Disengage control motor lever -E- from connecting rod -F-.
Installing:
Install in reverse order of removal, noting the following.
NOTE:
-
After installing, check motor/flap function.
-
Initiate "Basic Setting" function using Vehicle Diagnostic, Testing and Information System VAS 5051/5052 in operating mode "Guided Fault
Finding".