GTI L4-2.0L Turbo (BPY) (2007)
Air Door Cable: Service and Repair
Temperature Flap - Bowden Cable, Removing and Installing
Temperature Flap - Bowden Cable, Removing And Installing
Removing:
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Remove heating and ventilation controls
-
Reach into center console and disengage locking mechanism -1- of Bowden cable sheath -2- and remove Bowden cable sheath from mount.
-
Disengage ball on Bowden cable -3- from operating lever.
-
Remove driver side footwell trim
-
Unclip Bowden cable at adjusting unit of temperature flaps -A- and unclip heating and ventilation unit -B-.
Installing
Install in reverse order of removal, noting the following: