volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Compressor Pulley|Locations|Page 10860 > < Compressor Pulley|Locations
Page 1
background image

Compressor Pulley: Service and Repair

Ribbed Belt Pulley - "Denso" A/C Compressor, Removing And Installing 

Removing 

-

Carefully remove circlip -A-, e.g. with a small screwdriver or needle-nose pliers (be especially careful that the ribbed belt pulley is not damaged
when doing this).

-

Hold A/C compressor input shaft -B- firmly in place using a standard Allen wrench or a socket wrench from Shock Absorber Set T10001
(depending on version of compressor) and rotate drive plate -C- along with ribbed belt pulley -D- in direction of arrow -E- (tightening torque 35
Nm
).

-

Remove drive plate -C-.

-

Remove circlip -A-.

-

Remove ribbed belt pulley -B-.

Installing 

NOTE: 

-

Replace circlip -A-.

-

Clean A/C compressor flange before sliding on ribbed belt pulley.

-

When installing circlip -A-, note that it cannot be bent open more than is necessary for installation.

-

Install ribbed belt pulley -B-.

-

Insert circlip -A- on correct side, the side with beveled insertion edge -C- faces away from A/C compressor (install flat side facing compressor).

-

Insert rubber elements -D- in ribbed belt pulley -B- according to illustration.

Compressor Pulley|Locations|Page 10860 > < Compressor Pulley|Locations