GTI L4-2.0L Turbo (BPY) (2007)
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) J623.
-
Using a Multimeter, check the Brake Light Switch F / Brake Pedal Switch F47 electrical harness connector to the Motronic Engine Control
Module (ECM) J623 electrical harness connector T94 for open an circuit.
Brake Light Switch F / Brake
Motronic Engine Control Module
Pedal Switch F47 electrical
(ECM) J623 electrical connector
harness connector terminals
T94 terminals or test box sockets
1
47
3
25
Specified value: 1.5 Ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply was not OK:
-
Replace the Motronic Engine Control Module (ECM) J623.
-
Install the drivers side storage compartment.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 03: Interrogating Fault Memory
2. If necessary, erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 04: Reset/Delete Diagnostic Data
3. If the DTC memory was erased, generate readiness code.
-
End of diagnosis.