GTI L4-2.0L Turbo (BPY) (2007)
Electrical Accessory Panel: Service and Repair
Relay Panel Integrated With Vehicle Electrical System Control Module J519, Removing and
Installing
Relay Panel Integrated With Vehicle Electrical System Control Module J519, Removing And Installing
NOTE:
-
The relay panel integrated with Vehicle Electrical System Control Module J519 is permanently attached and cannot be serviced separately.
-
If Vehicle Electrical System Control Module J519 is to be replaced, the work procedure to read out the coding stored in the module must always
be performed.
Removing:
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Remove drivers footwell cover.
-
Remove drivers storage compartment where applicable.
-
Disengage electrical connection lock -1- in direction of -arrow A-.
-
Disengage electrical connection lock -2- at Vehicle Electrical System Control Module J519 in direction of -arrow B-.
NOTE: Harness connectors of Vehicle Electrical System Control Module J519 and of relay carrier at vehicle electrical system control module, at
left instrument panel, can only be disconnected if lock is brought into position "OPEN" beforehand.
-
Disconnect all electrical connections to relay panel.
NOTE: The number of electrical connections depends on vehicle equipment.
-
Unclip Vehicle Electrical System Control Module J519 with relay panel from latches -arrows C-.
-
Pull Vehicle Electrical System Control Module J519 with relay panel downward and out of bracket in opposite direction of travel.
Installing:
Install in reverse order of removal, noting the following:
NOTE: Electrical connection locks can only be brought into position " CLOSE" when all connections are connected "correctly".