GTI L4-2.0L Turbo (BPY) (2007)
-
Compare the fuel quantity pumped with the specified value.
*) Minimum delivery rate cu.cm /30 s
**) Voltage at the fuel pump with the engine off and the fuel pump running (approx. 2 Volts less than battery voltage).
Read-out example:
During test, a voltage of 12.5 Volts is measured at battery. Since voltage at the pump is approx. 2 Volts less than battery voltage, there is a minimum
delivery rate of approx. 580 cu.cm /30 s.
If the minimum delivery rate is not obtained:
-
Check fuel lines for restrictions (kinks) or clogging.
If no malfunction can be found:
-
Disconnect the supply hose -1- from the fuel filter input.
-
Connect a High pressure fuel gauge between the fuel filter and fuel supply line.
-
Repeat the delivery rate test.
If the minimum delivery rate is obtained:
-
Replace the fuel filter.
If the minimum delivery rate is not obtained:
-
Remove the fuel pump and check the strainer filter for dirt.
If no malfunctions have been found:
-
Replace the fuel pump.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03:
Interrogating Fault Memory
2. If necessary, erase the DTC memory. See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic
Mode 04: Reset/Delete Diagnostic Data
3. If the DTC memory was erased, generate readiness code.
-
End of diagnosis.