volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

CAN-BUS Terminal Resistance, Checking|Page 4519 > < CAN-BUS Terminal Resistance, Checking|Page 4517
Page 1
background image

Engine Control Module: Testing and Inspection
Voltage Supply, Checking

Voltage Supply, Checking 

Special tools, testers and auxiliary items required 

-

Multimeter.

-

Wiring diagram.

Test requirements 

-

The Motronic Engine Control Module (ECM) J623 fuses OK.

-

Battery voltage at least 12.5 volts. 

-

All electrical consumers such as, lights and rear window defroster, switched off.

-

Vehicles with automatic transmission, selector lever in position "P" or "N".

-

A/C switched off.

-

Ground (GND) connections between engine/transmission/chassis OK.

-

Ignition switched off.

Test sequence 

-

Remove the Motronic Engine Control Module (ECM) Power Supply Relay J271

Checking voltage 

-

Using a Multimeter, check the Motronic Engine Control Module (ECM) Power Supply Relay J271 socket 1/30 to Ground (GND).

Specified value: battery voltage. 

If the specified value was not obtained:

-

Check the wiring connections from the Battery to the Motronic Engine Control Module (ECM) Power Supply Relay J271 socket 1/30 for an open
circuit or a short circuit.

-

Check the wiring connections for damage, corrosion, lose or broken terminals.

-

If necessary, repair the faulty wiring connection.

If the specified value was obtained:

-

Switch the ignition on.

-

Using a Multimeter, check the Motronic Engine Control Module (ECM) Power Supply Relay J271 socket 3/86 to Ground (GND).

Specified value: battery voltage. 

If the specified value was obtained:

Checking wiring 
If the manufacturers test box is being used. Perform the following step.

-

Install the test box.

If the manufacturers test box is not being used. Perform the following step.

-

Remove the Motronic Engine Control Module (ECM) J623.

-

Using a Multimeter, check the Motronic Engine Control Module (ECM) Power Supply Relay J271 socket 3/86 to the Motronic Engine Control
Module (ECM) J623 electrical harness connector T94 terminal 92 for resistance.

Motronic Engine Control

Motronic Engine Control Module (ECM)

Module (ECM) Power Supply

J623 electrical connector T94

CAN-BUS Terminal Resistance, Checking|Page 4519 > < CAN-BUS Terminal Resistance, Checking|Page 4517