GTI L4-2.0L Turbo (BPY) (2007)
Clutch Switch: Service and Repair
Clutch Position Sensor G476, removing and installing 02Q, 6 Speed M/T
Special tools, testers and auxiliary items required
^
Hose Clamps Up to 25 mm dia. 3094
Removing
-
First check whether a coded radio is installed. In this case, find out anti-theft coding.
-
Disconnect battery Ground (GND) strap with ignition switched off.
-
Remove entire air filter housing, if it is located in the vicinity of the battery.
-
Remove battery and battery carrier.
If a hose/line assembly - 1 - with a round component is installed directly below the master cylinder, hose/line assembly must be removed.
Note: While performing the following work, make sure that no brake fluid comes into contact with longitudinal member or with transmission. If this
happens, these areas must be cleaned thoroughly.
-
Use Hose Clamps Up to 25 mm dia. 3094 to clamp supply hose to master cylinder.