GTI L4-2.0L Turbo (BPY) (2007)
-
Disengage securing clip - 2 - using a screwdriver and pull out of master cylinder until it stops.
-
Disconnect hose/line assembly - 1 - from master cylinder and plug it.
All vehicles
-
Disconnect electrical connector - 4 -.
-
Unclip Clutch Position Sensor G476 on master cylinder - arrow - and remove.
Installing
Installation is in reverse order of removal. Note the following:
Note:
^
Replace seals.
If hose/line assembly was removed:
-
Press in hose/line assembly - 1 - with new sealing ring - 2 - to connection of master cylinder - 4 - until securing clip - 3 - engages audibly.
-
Verify by pulling on hose/line assembly.
-
Bleed clutch system.
All vehicles
-
Install battery carrier and battery.
-
Install complete air filter housing, if it is located in the vicinity of the battery.
-
Connect battery and observe work procedures for after connecting the battery.