GTI L4-2.0L Turbo (BPY) (2007)
/Page-1800004.png)
Installation position of spring retainer
Tighten hex bolts - arrows - for upper strut mount.
-
Install plenum chamber cover.
-
Install wiper arms.
-
Secure Engine/Transmission Jack V.A.G 1383 A with Wheel Hub Support to wheel hub using a wheel bolt.
CAUTION!
^
Do not lift or lower vehicle when the engine/transmission hoist V.A.G 1383 A stands below the vehicle. Vehicle could slip off lift.
^
Do not leave engine/transmission jack V.A.G 1383 A below vehicle any longer than necessary.
-
Position suspension strut on wheel bearing housing.
-
Remove wire on wheel bearing housing.
-
Carefully lift wheel bearing housing with engine and transmission jack enough so that the suspension strut/wheel bearing housing bolt can be
inserted.
-
To do so, press brake disc by hand in direction of suspension strut while lifting.
Otherwise strut tube may be canted in hole of wheel bearing housing.
-
Remove spreader 3424.
