GTI L4-2.0L Turbo (BPY) (2007)
Shifter A/T: Service and Repair
Selector Mechanism, Overview
Selector mechanism 02E, 6 Speed Direct Shift A/T
CAUTION! Shift selector lever into position "P" and engage parking brake before working with the engine running.
Selector mechanism, overview
1 -
Shift cover with knob
^
Rabbit/GTI knob is shown in illustration at left.
^
Do not remove knob if not necessary. For emergency release, only cover must be removed.
^
In right illustration: Before removing knob, pull button past pressure point and secure using cable tie or suitable wire. This prevents button
from being pushed into knob accidentally.
^
Rabbit/GTI: Do not press button. If it is pressed, knob must be removed and prepared for installation
2 -
Selector lever and selector mechanism
^
With Shift Lock Solenoid N110
^
Brief description of removal and installation:
-
Remove center console.
-
Remove cable from transmission.
-
If necessary: Disconnect or remove.
-
Remove heat shield beneath vehicle.
-
Adjust selector lever cable after installing.
3 -
Bolt with spring
^
3 Nm
4 -
Pin
^
Do not grease
5 -
Securing plate
^
Always replace after removal
6 -
Nut
^
9 Nm
^
Qty. 4
7 -
Shift housing