GTI L4-2.0L Turbo (BPY) (2007)
/Page-1328002.png)
CAUTION! Do not press clutch pedal after hose/line assembly has been removed.
Remove hose/line assembly at the bleeder as follows:
-
Release securing clip - 2 - with a screwdriver and pull hose/line assembly - 4 - with O-ring - 3 - off from bleeder - 1 -.
Installing
Installation is in reverse order of removal, note the following:
Note: Replace O-rings.
-
Press hose/line assembly - 1 - with new O-ring - 2 - into connection of master cylinder 4 -, until securing clip - 3 - audibly engages.
-
Verify by pulling on hose/line assembly.
-
Press hose/line assembly with new O-ring - 3 - into connection of bleeder, until securing clip audibly engages.
-
Verify by pulling on hose/line assembly.
-
Bleed clutch system.
-
Install entire air filter housing.
