GTI L4-2.0L Turbo (BPY) (2007)
Pressure Plate: Service and Repair
Clutch, Removing and Installing
Clutch, removing and installing 02Q, 6 Speed M/T
Removing
-
Remove transmission.
-
Insert flywheel retainer 3067 to loosen bolts.
-
Loosen bolts in small stages in diagonal sequence.
-
Remove pressure plate and clutch plate.
Installing
Installation is in reverse order of removal, note the following:
Note:
^
Allocate thrust plate and clutch disc.
^
Make sure alignment sleeves for engine to transmission are installed in cylinder block, install if necessary.
^
If alignment sleeves are not present, shifting difficulties, clutch problems and possibly noise in transmission (loose gear rattling) will occur.
Installation position of clutch plate
^
Marking "Getriebeseite" (transmission side) faces toward transmission.
Checking ends of the diaphragm spring
^
Wear up to half the thickness of diaphragm spring - arrows - is permitted.
Check spring connections and rivet connections
-
Check spring connections - arrows A - for damage and rivet connections - arrows B - for secure fit.