GTI L4-2.0L Turbo (BPY) (2007)
-
Bend taps - arrows - on shift mechanism base plate up with a screwdriver and remove base plate (the tabs in front area of base plate are not
shown).
-
Remove seal from shift housing.
-
Remove shift cable and selector cable from selector housing.
-
Then remove shift lever from shift lever guide.
-
To remove lock washer - arrow A - from shift lever, spacer bushing - arrow B - must be pressed in direction of - arrow C - as far as stop using a
screwdriver and then lock washer must be removed.
Note:
^
Do not tilt bushing when pushing down.
^
Groove in shift lever for lock washer must be visible.
^
Carefully release tension on spring.
-
Raise upper side of spring - A - over selector bracket tab.
-
Using a screwdriver, press bearing shell notches - arrows - in direction of shift lever guide bearing; break of notches if necessary.
-
Pry out bearing shell - A - with shift lever guide - B - from selector housing.