GTI L4-2.0L Turbo (BPY) (2007)
Note: The selector bracket is only partially shown to provide a better illustration.
-
Move selector bracket back as far as stop (opposite mounting holes for shifter and selector cable) - arrow 1 -.
-
Lubricate ball head pins.
-
Press ball head pins into selector bracket - arrow 2 -
^
Guides - A - and tabs - B - must not be damaged.
-
Place selector housing with shift lever guide in larger depression - arrow - on Pressing Support T10083.
^
The shift lever guide must project out of selector housing as far as stop.
-
Raise upper side of spring - A - over selector bracket pins.
^
Use a new bearing shell - B -.
-
Lubricate bearing shell and shift lever guide bearing.
-
Press bearing shell onto shift lever guide bearing as far as stop.
-
Remove selector mechanism from Pressing Support T10083.
-
Insert lower side - C - of spring into guide.
-
Raise upper side of spring - A - over selector bracket pins into guide.
-
Press bearing shell into selector housing - arrows -.
^
All retaining tabs must engage.
-
Install shift lever, shift cable, selector cable and base plate.
-
Install selector mechanism.