GTI L4-2.0L Turbo (BPY) (2007)
Windshield Washer Pump: Service and Repair
Windshield And Rear Window Washer Pump V59, Removing And Installing
NOTE: Depending on equipment, location of Windshield and Rear Window Washer Pump V59 may differ slightly from illustrations. Removal is
performed in the same way.
Removing:
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove front bumper cover.
NOTE: In order to prevent interchanging washer fluid line connections at Windshield and Rear Window Washer Pump V59, connections at pump
and hose lines are color coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.
-
To release, twist securing clips at hose connections -3- and -5- and disconnect them from Windshield and Rear Window Washer Pump V59 -4-.
-
If necessary, catch draining fluid using a suitable container.
-
Remove Windshield and Rear Window Washer Pump V59 -4- upward out of reservoir.
-
Disconnect electrical connection -2-.
Installing:
Install in reverse order of removal, noting the following:
-
Tighten all fasteners according to value in table.
-
Bleed headlamp washer system after completing assembly work.