volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Ribbed Belt Pulley, Denso A/C Compressor|Page 1078 > < Drive Belt|Locations|Page 1075
Page 1
background image

Drive Belt: Service and Repair
Ribbed Belt Pulley, Denso A/C Compressor

Ribbed Belt Pulley, Denso A/C Compressor

Removing

-

Carefully remove circlip - A -, e.g. with a small screwdriver or needle-nose pliers (be especially careful that the ribbed belt pulley is not damaged
when doing this).

-

Hold the A/C compressor input shaft - B - firmly in place using a standard Allen wrench or a socket wrench from the shock absorber set T10001
(depending on the compressor version) and rotate the drive plate - C - and ribbed belt pulley - D - in the direction of the arrow - E - (tightening
specification 35 Nm).

-

Remove drive plate - C -.

-

Remove circlip - A - .

-

Remove ribbed belt pulley - B -.

Installing

NOTE:

-

Replace circlip - A -.

-

Clean A/C compressor flange before sliding on ribbed belt pulley.

-

When installing circlip - A -, note that it cannot be bent open more than is necessary for installation.

-

Install ribbed belt pulley - B -.

Ribbed Belt Pulley, Denso A/C Compressor|Page 1078 > < Drive Belt|Locations|Page 1075