GTI L4-2.0L Turbo (CBFA) (2008)
Antitheft Mode Switch: Service and Repair
Interior Monitoring Deactivation Switch and Deactivate Vehicle Inclination Sensor Button
Special tools, testers and auxiliary items required
-
Trim removal wedge VAS 3409
NOTE:
-
To remove the Interior Monitoring Deactivation Switch E267 and Deactivate Vehicle Inclination Sensor Button E360, anti-theft warning
system must be deactivated.
-
When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool (trim
removal wedge VAS 3409, screwdriver) will be positioned, using commercially available adhesive tape.
-
Interior Monitoring Deactivation Switch E267 and Deactivate Vehicle Inclination Sensor Button E360 are located in B-pillar trim on drivers
side.
Removing
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Carefully pry out Interior Monitoring Deactivation Switch E267 and Deactivate Vehicle Inclination Sensor Button E360 using removal wedge
VAS 3409 or a screwdriver.
-
Release and disconnect the connector - arrow -.
Installing
Install in reverse order of removal.